Everything but Shipping

Small adapter bracket for PM-25MV mill only. Small gray cast alum. motor mount that clamps to the table. The other half that the motor mounts to is...

75T Change Gear for PM-1127VF-LB latheNot in schematic

Metal Spout for coolant system PM-1440BV Not in Schematic

Large Adapter for PM Bench Mill X axis Power feed. .Large gray cast alum. motor mount that that the motor attaches to. The other half that attaches...

L01-1 Joiner (90 deg elbow with check valve) This goes on the left side and right side of the oiler.

90 degree elbow L06 for PM-728VT, PM-833x mills used on the Z column above the pump, NOT on the pump.

MagXact DRO Scale, 5Um, 420mm DRO Scale, and 5Um Reader Head

Motor fan for PM-833TV. Located at the top of the motor under the fan cover. Not in schematic

1127VF-LB Change Gear Set, Not in schematic

Tailstock DRO for PM-1440-2SM and 1440-2SMV lathe

Brushed D/C motor for older PM-1127VF lathes

Replacement display for 3 Axis Easson ES-12 DRO for Milling Machines

Complete assembled tailstock for PM-1022V and PM-1030V lathe

SGC-4.2 350mm 5um scale with reader

39T change gear for PM-1122, PM-1130 Lathe

Replacement Jaws (outside) for PM-1022, PM-1030 LatheNot in Schematic

Gated detent for PM-1030V and PM-1022V. This detent is used in the apron to set the X and Z powerfeed handle. Not in schematic

Run capacitor 450VAC 20uF. Used for some legacy machines. Not for any current machines.

Complete steady rest for the PM-1228VF-LB lathe Not in schematic

D1-8 Camlock Stud - Pin For Lathe Chuck Or Face Plate, M20x1.5 ThreadsNot in Schematic

Tachometer display for the PM-1440HVT-2 lathe

Transformer for PM-739M mill

Bracket for Align powerfeed limit switch. Cast aluminum part that mounts to the carriage and hangs the limit switch.

3 jaw chuck with backing plate for PM-1022V and PM-1030V lathe