Everything but Shipping

Part #4 Knob nut For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r4 70064

Part #5 Clamp screw For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r5 70033

Part #6 Hinge pin For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r6 70032

Part #7a Top casting, Base casting For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r7a 70029, 14-70030

Part #7b Top casting, Base casting For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r7b 70029, 16-70030

Part #8 Single wing bolt For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r8 70063 Note: later models a replaced by m8x16 set screw

Part #9 Nut M12 For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r9

Part #10 Spring washer M12 For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r10

Part #11 Hexagon head bolt M12x75 For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r11

Part #12 Clamp plate For PM-1440TL PM-1640TL PM-1660TL Lathe TLF14r12 70039

Part #1 Adjusting screw Spring pin Collar Screw 4x40 For PM-1440TL PM-1640TL PM-1660TL Lathe TLF15r1 70038, 70062, 70045

Part #2 Finger, Bracket For PM-1440TL PM-1640TL PM-1660TL Lathe TLF15r2 70044, 70047

Part #3 Set screw SET 8x8 For PM-1440TL PM-1640TL PM-1660TL Lathe TLF15r3

Part #4a Casting For PM-1440TL PM-1640TL PM-1660TL Lathe TLF15r4a 14-70041

Part #4b Casting For PM-1440TL PM-1640TL PM-1660TL Lathe TLF15r4b 16-70041

Part #5 Single wing bolt For PM-1440TL PM-1640TL PM-1660TL Lathe TLF15r5 70063

Gear Change Chart on belt cover PM-1228VF-LB latheNot in schematic

Thread Dial Chart for apron PM-1228VF-LB latheNot in Schematic

Small Adapter for Align ALB500D X power feed for PM-728VT Small gray cast alum. motor mount that clamps to the table. The other half that the motor...

Left/Right switch for PM-727V, PM-727M mill one each direction.Not in Schematic

Quill Down Feed Handle #190 for PM-835S, 935T, 949T, 1054T, 950 Milling machinesNot in Schematic ALSO see Z9064, same part

Rapid Feed switch for Align Power feed.(listed as anti vandal switch in manual, C0509 Parts List #5)

.016' spacer for installing MagXact DRO read heads.

Spindle Bore to MT3 Reducing Sleeve, part of standard equipment on PM-1440GT Lathes. Reduces 2' Spindle Bore Taper (MT5.5) to MT3 Taper, used for t...