Everything but Shipping

Part#2 steel flexible oil line for Z axis PM-833T millNot in schematic

Part#7 Steel flexible oil line to work stable PM-833TNot in Schematic

Motor endcap (fan end) for CS-315 sawNot in Schematic

E-stop switch for TL series Lathes Not in Schematic

DRO mounting bracket for 1236 lathe

Pinion Gear for PM-1022 and PM-1030 three jaw chuck to tighten and loosen jaws

Old speed board for PM-25 millSpecial Order ONLY

Cast foot pad for 833 stand. Pad only, no leveling screw.

Replacement scale 1Um high res scale ASD8 120mm

Roll Pin for PM-1022, PM-1030 Latheattaches Z7384 pinion to Z1253 cross slide leadscrew Shown in inset picture on Page 30, Fig 5ANot in Schematic

Back plate for 4-jaw chuck of PM-1022, PM-1030 lathe. This backplate has 4 mounting holes instead of 3 as for the 3-jaw chuckNot in Schematic

Cast Iron Base/Stand for the PM-940940MF6r78

Part #1 Plug For PM-25MV Mill 25MVF5r1

Part #2 Box For PM-25MV Mill 25MVF5r2

Part #3 Front panel For PM-25MV Mill 25MVF5r3

Part #4 Screw M4x8 For PM-25MV Mill 25MVF5r4

Part #5 Emergency stop switch For PM-25MV Mill 25MVF5r5

Part #6 Potentiometer for PM-25MV, PM-30MV, PM-727V speed dial 25MVF5r6

Part #7 Direction switch For PM-25MV Mill 25MVF5r7

Part #8 Power ON/OFF For PM-25MV Mill 25MVF5r8

Part #9 Fuse (10A) For PM-25MV Mill 25MVF5r9

Part #10 Washer 4 For PM-25MV Mill 25MVF5r10

Part #11 Tach display For PM-25MV Mill 25MVF5r11

Part #12 Contactor rail For PM-25MV Mill 25MVF5r12