Everything but Shipping

Old speed board for PM-25 millSpecial Order ONLY

Cast foot pad for 833 stand. Pad only, no leveling screw.

Replacement scale 1Um high res scale ASD8 120mm

Roll Pin for PM-1022, PM-1030 Latheattaches Z7384 pinion to Z1253 cross slide leadscrew Shown in inset picture on Page 30, Fig 5ANot in Schematic

Back plate for 4-jaw chuck of PM-1022, PM-1030 lathe. This backplate has 4 mounting holes instead of 3 as for the 3-jaw chuckNot in Schematic

Cast Iron Base/Stand for the PM-940940MF6r78

Part #1 Plug For PM-25MV Mill 25MVF5r1

Part #2 Box For PM-25MV Mill 25MVF5r2

Part #3 Front panel For PM-25MV Mill 25MVF5r3

Part #4 Screw M4x8 For PM-25MV Mill 25MVF5r4

Part #5 Emergency stop switch For PM-25MV Mill 25MVF5r5

Part #6 Potentiometer for PM-25MV, PM-30MV, PM-727V speed dial 25MVF5r6

Part #7 Direction switch For PM-25MV Mill 25MVF5r7

Part #8 Power ON/OFF For PM-25MV Mill 25MVF5r8

Part #9 Fuse (10A) For PM-25MV Mill 25MVF5r9

Part #10 Washer 4 For PM-25MV Mill 25MVF5r10

Part #11 Tach display For PM-25MV Mill 25MVF5r11

Part #12 Contactor rail For PM-25MV Mill 25MVF5r12

Part #13 Contactor For PM-25MV Mill Z9055 25MVF5r13

Part #14 Control board For PM-25MV Mill 25MVF5r14Potentiometer (Z1044) and speed display (Z9595) MUST be replaced along with the board.Previous SKU...

Part #15 Nut M4 For PM-25MV Mill 25MVF5r15

ASD4 5um 350mm scale (with reader) for Biga DROs

ASD4 5um 450mm scale (with reader) for Biga DROs

DRO Display unit for PM-1440E-LB