Everything but Shipping

Rubber o-ring for one shot oil pump on PM-728VT millNot in Schematic.

Tubing Ferrule for T-coupler on one-shot oiler for PM-728VT mill. This is NOT a normal compression ring.Not in schematic

Aluminum switch panel for PM-1340GT lathe. This panel sits above the gearbox and holds the electrical switches, but does not include the switches.N...

Full handle assembly for CS-315 cold saw. Includes parts: Z7786 Z7787 Z7788 Z7789

Steady Rest for PM-1130V latheNot in Schematic

51204 bearing for top of Z Axis leadscrew on PM-940M mill Not in Schematic.

Complete Steady Rest for PM-1440-2SM, and PM-1440-2SMV LathesIncludes top and bottom casting, fingers, rollers, all hardware

Complete Follow Rest for PM-1440-2SM, and PM-1440-2SMV LathesIncludes casting, fingers, rollers

Set of (4) replacement jaws for 4-jaw chuck supplied with PM-1022V and PM-1030V.

SGC-4.2 450mm Scale Used on the Z axis of the PM-727m and PM-727V mills

Part#31 Spindle Sleeve (quill) for PM-940V Mill. Quill body only, no other parts.

Part#51 Spindle for PM-940V Mill. Bare spindle no other parts.

Part#2 Handwheel for carriage feed on PM-1440-2V, PM-1440-2SM lathe

Face Plate for PM-1022V, PM-1030V latheNot in schematic

Thread dial complete with housing for PM-1022V, PM-1030V latheNot in schematic

#35 Bottom Cover for Align Knee Mill Power Feeds Not in Schematic

Steady Rest for PM-1340GT LatheNot in Schematic

Screw set for Spider on PM-1440BV. Set of 4 screws

TFT display for MX-200 DRO. Replacement for screens that have failed.

Filter transformer board for PM-1127VF lathe (separate from the speed control board)

Part# 16 White Clamp Assembly for taper attachment for PM-1236T, PM-1340GT,PM-1440GT Lathes This clamps to lathe bed and holds the Tie Rod.

Tie Rod Clamp for Taper Attachment on PM-1236T, PM-1340GT, PM-1440GT Lathesincludes Part#18 and Part#19, but not the Tie rod, #15

Pointer for angle scales. Self-Adhesive. May fit multiple machines. 0.47' on center spacing for the rivets (not drilled). 0.78 x 0.4 rectangle with...

Red arrow + line zero position plus two rivets for PM-935, PM-949, PM-1054 Knee Mills.0.918' x 0.273' rectangle with pre-drilled holes 0.65' apart....