Everything but Shipping

Morse taper reducing sleeve for the spindle of the 1440TL, 1640TL, and 1660TL lathes. MT6 reduces to MT4

Drive gear for ALb-310S-X power feed. This is the gear that attaches to the leadscrew and has a lovejoy style coupler on one side.Not in Schematic

Signal cable for RPM display on PM-1440HVT-2 lathe. Includes speed knob

Spindle sleeve for PM-1440HVT-2 lathe. Originally sent to correct chatter in gearbox, but the issue was corrected in VFD setting.

220V 3ph motor for PM-835S Knee MillNot in Schematic

Start Capacitor 500mfd for PM-950 Mills

Replacement Jaw set for Taiwan 4-jaw chuck. 4 pieces.Note: dimensions must be provided to vendor to order this.

Part #16 Oiler 6 For PM-1022 PM-1030 Lathe 1030F5r16

Coolant switch and relay for 1440HVT-2 lathe Not in schematic

Complete compound assembly for PM-1022 and PM-1030 lathes

Fuse holder and terminal strip for 1440HVT lathe

Replacement PCB board for Ditron D80 DRO

E-Stop switch For PM-1130 Lathe Not in schematic

Plastic tubing for one shot oiler on the PM-728VT. Tubing is 4mm diameter and 11cm length

Plastic tubing for one shot oiler on the PM-728VT. Tubing is 4mm diameter and 25.5cm length

Plastic tubing for one shot oiler on the PM-728VT. Tubing is 4mm diameter and 27cm length

#3 set screw for 5C Collet chucks. Used to retain the #4 anti-rotation pin in the chuck.

#4 anti-rotation pin for 5C collet chucks. This is used to prevent the collet from spinning.

Part #17 Cmpnd leadscrew flange For PM-1022 PM-1030 Lathe 1030F5r17

#31 Flange PM-1440HD Latheused to mount worm screw for power feed on apron

#32 5x56 Key for PM-1440HD Latheused for wormscrew 34 on the apron assembly

#33 3x5 Pin PM-1440HD latheused on worm screw 34 in apron assembly

#34 Worm for PM-1440HD Power feed on Apron

#35 Collar for PM-1440HD LatheRetains worm screw on back of apron. 2 required.