Everything but Shipping

#34 Worm for PM-1440HD Power feed on Apron

#35 Collar for PM-1440HD LatheRetains worm screw on back of apron. 2 required.

#39 Gear for PM-1440HDFor Shaft D of Apron

Forward/Reverse power switch with cord for 935, 949, 1054 knee mills. Single phase models only.

Forward/Reverse power switch with cord for 935, 949, 1054 knee mills. Three phase models only.

Tool post graduated scale (degrees) for PM-1440E-LB lathes.Not in Schematic

Tool post graduated scale (degrees) for PM-1440-BV lathes.Not in Schematic

KM1-01 Auxiliary contact to fit contactors on PM-1236 lathes with Eaton contactors.

Power transformer for PM-1440E-LB lathetransformer has 220v input, and taps for the DRO and contactors/light

straight pin retains Gear#16 in PDF assembly. 2 required. PM-940M/V PM-932M/VNot in schematic

Black plastic wire box for PM-932 motorholds wire connections and capacitors on the side of the motor.

Forward/Reverse power switch with cord for PM-950 mill. Single phase models only.

Centrifugal Switch and Contact for PM-950 Mill

Belt for PM-1236 LatheNot in Schematic

Power filter for speed display on PM-1130V lathe. Small white box.Not in Schematic

External Jaw set for 3 jaw chuck PM-1022,PM-1030 latheNot in schematic

Nut for fastening the guide fingers in the steady rest for PM-1330V lathe

#027 Mounting Flange for PM Power feed for Knee Mills.Gray flange with two pairs of vertical mounting holes, one pair each side of the leadscrew.

Part #19 Graduated collar For PM-1022 PM-1030 Lathe 1030F5r19

Contactor for PM-1022 and PM-1030 lathes

SGC-4.2 800mm scale with reader for lathe DRO

Screw to adjust fingers on follow rest and steady rest of PM-1022 and PM-1030 lathe

Replacement board for 3 axis LCD DRO display. This is not the entire unit, just the front panel with keyboard and display.

Potentiometer/ speed control knob for PM-932V and PM-940V