Quick Change Toolpost Set, Wedge Type #100 (AXA) with 5 holders:
- (1) 250-101 Straight Holder, 1/4-1/2″ Capacity
- (1) 250-102 Straight w/V Groove for straight OR round tools, 1/4-1/2″ Capacity
- (1) 250-141 H.D. Boring Holder, 5/8″ Capacity
- (1) 250-110 Knurling / Facing Holder
- (1) 250-107 Parting Holder, Uses 1/2″ Tall Parting Blades
Sizing:
(This tool post will generally fit lathes from 10″ to 12″ Swing, please check carefully as shown below)
Measure from the top of your compound slide, where the tool post sits, to the centerline of the spindle/work piece (Using a center in the tailstock to find this is normally the easiest way) For this AXA Tool Post Set, you will need a minimum of 1″ from that measurement, up to a maximum of about 1-3/4″. If it is more than this 1-3/4″, you want to use a larger tool post to fit it properly.
Diminsions Below for standard straight tool holder to help with sizing:
- A: 15/16″
- B: 1/2″ (This is where the cutting tool fits)
- C: 7/16″
- D: 1-1/2″
Flat rate of $15.99 shipping anywhere in the 48 States